Because it has already been proven to increase tool life, through put, part quality, and in some areas reduce the noise and vibration levels of machinery.
Because it has enabled the user to align certain processes that were not previously alignable.
Because when using an indicator we would perform an alignment but always left out at least one step in the alignment process.
Or the part was brought into tolerance by running a part and having it checked on the Coordinate Measuring Machine and making the alignment moves according to the CMM. No one really knew what was done to bring the part into spec. or what the tooling was going through to produce the part. With the laser you align the spindle to the master and run parts.
Because when a machine is correctly aligned it is operating under reduced stresses. In turn the spindle bearings, drive mechanism, spindle motor are using less energy to operate.
Because the system has been proven over and over again in the big three, machine manufacturing plants, and their subsidiaries.
Because Hamar Laser is the only company that offers a target that reads and displays the angle and center simultaneously.
Because Hamar Laser is continuously upgrading its equipment to meet the needs of its customers.
Because the software is Windows based and can generate a detailed report.
Because equipment vibrates, shakes, and moves when operating under normal circumstances. This in turn affects alignment, which in turn affects part quality, tool life, internal stresses, noise levels, and energy use.
