Maintenance Diagnostic Systems, Inc. Extruder Alignment Certification Course Basic

We are ensuring that the simulated transfer line is flat and straight and that the wing bases are perpendicular to the line, in preparation to begin the setting of the spindle boxes and begin spindle alignment.

Prerequisite: None

Class Length: 8 Hours

Class Size: 6 Students

SPECIFIC NEEDS TRAINING ADDRESSES:

It will provide the necessary information to operate the software and equipment. This course will give the trainees the knowledge of proper bore alignment using the laser as the datum and T-218, A-510 targets to measure bores.

COURSE DESCRIPTION:

This course will provide theory explanation and hands on training in the following areas:

1. Proper alignment procedures.
2. Inspection areas requiring periodic examination.
3. Equipment identification and operation.
4. Equipment installation and connections.
5. Software installation and operation for Read8/Bore8.
6. Set-up and measurement of barrel using the Hamar Laser Extruder Alignment System (L-705/L-706 system).

PERFORMANCE OBJECTIVES:

Trainee will be able to:

1. Determine the amount of bore misalignment to the laser datum.
2. Correctly assemble and install target adapter, laser, and target.
3. Correctly connect the equipment (target, interface/readout, laser and computer).
4. Install, set-up, and operate the Hamar Bore software.

COST:

Training rates do not include travel or living expenses for instructor when performing in-plant training. Manuals are $50.00 each. Refer to the field service rate sheet for expenses.

Please Contact Us for more information about tuition cost.